1. After daily operation, it is the driver's responsibility to pour clean water into the mixing tank and rotate it at high speed (14-18 RPM) for 5-10 minutes, and then drain the water to ensure that the drum is clean. When cleaning all parts of the mixing drum with high-pressure water, care should be taken to avoid using parts such as appearance and operating lever. The distance between the pressure water nozzle and the exterior of body paint shall not be less than 40 cm.
2.在施工現場卸貨后，應使用自動上料的攪拌車隨附的軟管沖洗料斗，料斗，卸料斜槽等，以附著在車身上的污泥和混凝土。在返回攪拌站的途中，應將150-200 L的水注入攪拌罐，以除去粘附在攪拌罐壁和葉片上的混凝土殘渣。液壓系統的壓力應符合使用說明書中的規定，不能隨意調節。液壓油的質量和數量應符合原始要求。
2. After unloading at the construction site, the hose attached to the automatic loading mixer should be used to flush the hopper, hopper, discharge chute, etc. to remove the sludge and concrete attached to the vehicle body. On the way back to the mixing plant, 150-200 l of water shall be injected into the mixing tank to remove the concrete residue adhering to the tank wall and blades. The pressure of the hydraulic system should be in accordance with the provisions of the operation manual, and can not be adjusted at will. The quality and quantity of hydraulic oil shall meet the original requirements.
3.在冬季施工中，應做以下工作：開始前檢查是否結冰；下班后，仔細清潔混合罐和供水系統中的殘留水，關閉泵的開關，并將控制手柄置于“停止”位置。
3. In winter construction, the following work should be done: check whether there is icing before starting; after work, carefully clean the residual water in the mixing tank and water supply system, turn off the pump switch, and put the control handle in the "stop" position.
4.了解自動上料的攪拌車的結構，工作原理和操作方法。
4. Understand the structure, working principle and operation method of automatic feeding mixer.
自動上料的攪拌車清潔作業對性能是很重的。
The cleaning operation of automatic feeding mixer is very important for performance.
